DVDLogic IGEditor 2.x guide

© 2010-2013 DVDLogic Software. All Rights Reserved

IGEditor 2.0

Navigation commands writing

In right part of main window is located panel for navigation commands writing. Syntax is highlighted that helps to see errors while writing. Correctness checking is process in the

same time with writing and errors are shown in log on the panel. Navigation commands will be assigned to button only if they pass the compilation successfully.

Common rules for navigation commands writing:

  • Parameters are set with 3 ways:
  • using symbols «[» and «]» for general purpose registers, for example [10]
  • using symbols «{» and «}» for system registers, for example {30}
  • constants are set without any symbols, for example 20
  • If command has 2 parameters, then first is destination and second is source parameter
  • All parameters in command are set through space, for example Move [10] 12 Full navigation commands list here …

© 2010-2013 DVDLogic Software. All Rights Reserved

IGEditor 2.0

Adding commands using wizard

  1. Select empty line in commands editor.
  2. Click Popup menu and select item «add command».
  3. In proposed list select command type: «Branch», «Compare», «Set» or «Menu» specific command.
  4. In new list select needed command.
  5. Wizard will propose you select special parameters in new window, see example (for Move command).

  1. After parameters selection please click «Ok» and you will see new command in commands editor.